Wilson SCG 346

New Users (or anyone else) is/are welcome to ask questions in here to which the answers might be obvious to most but you simply don't know yourself or are unsure where to find the answer. You can also ask questions about the working of the forum or anything else you may think of.

Moderator: MAN 16.242

Forum rules
### This section is a NO FLAMING ZONE! That means you cannot reply "harshly", abusively, sarcastically or in any negative manner to members. ###
Post Reply
localswede
Posts: 0
Joined: Tue Jan 31, 2023 12:44 pm

Wilson SCG 346

Post by localswede »

Hi!

Short introduction.

Ajokki B58, bought of facebook with engine stuck.
Wilson SCG gearbox
Swapped engine, new THD100 mounted, starts and runs well.

Gearbox/gearstick does not work.

One red wire to a sensor above the gearbox and one green wire together from a tube that goes to the front.

EPU has one ground mounted to it, but nothing that goes to the unit itself.

Gearstick has one grey, red, yellow and green cable from it.

3 Solenoids around the gearbox
Missing cable for the solenoid next to the EPU (Electrical Pneumatic Unit).

Where does this come from? Straight from the gearstick?

If anyone has instructions, photos or help with the wiring between the EPU and the Gearstick, any help would be appriciated.

Photos: https://ibb.co/album/1M2sY6

Regards
Ovansjö Racing
Post Reply

Return to “New Users/Ask a Simple Question”