Hello,
I am after as much information as possible and hopefully pictures of the inside of a Leyland OPS1 half cab bus.
I am in the process of restoring one for the Tasmanian Transport Museum.
Wanting to know particullarly -
. how the passenger stop bell worked. Was it electric or manual? Pull cord?
. Did they come out origionally with top lights or were they added later?
. What lights, if any, were on the rear?
. Hand rails and where were they located?
Any internal pictures and information gratefully accepted.
Leyland tiger OPS1
-
- Posts: 2
- Joined: Mon Mar 18, 2019 7:20 pm
- Location: Honart, Tasmania
Leyland tiger OPS1
Regards
Luke
Luke
Re: Leyland tiger OPS1
Try sending a PM to systemimprover
"Inside Every Progressive Is A Totalitarian Screaming To Get Out"
David Horowitz.
David Horowitz.
- system improver
- Posts: 2893
- Joined: Fri Dec 29, 2006 8:38 am
- Favourite Vehicle: 1949 MBA Seddon
- Location: Melbourne
Re: Leyland tiger OPS1
I'm already looking.1whoknows wrote:Try sending a PM to systemimprover
-
- Posts: 2
- Joined: Mon Mar 18, 2019 7:20 pm
- Location: Honart, Tasmania
Re: Leyland tiger OPS1
Thank you
Discovered today that pretty much both horizontal beams above and below windows are rotted and screws wont grip even what is viable, so basically to do a full restoration all panels and windows would have to come off, then timbers be renewed.
Will concentrate on the inside for now.
Discovered today that pretty much both horizontal beams above and below windows are rotted and screws wont grip even what is viable, so basically to do a full restoration all panels and windows would have to come off, then timbers be renewed.
Will concentrate on the inside for now.
Regards
Luke
Luke